Heating and air systems are an integral part of our homes. Most of us tend to take them for granted when they're working. But did you know: they could be working better and saving you money?
Take a look at the system diagram. Many of the items listed are probably unfamiliar to you, but not to us. We know all about them, and we'll put that knowledge to good use when we service your system.
It takes less than two hours to do a complete system tune-up and industry experts recommend it for any system over a year old.
Current Tune-Up Specials
 |
Tune-Up Checklist
- Calibrate and level thermostat.
- Clean filters as needed.
- Monitor volts/amps on fan motor.
- Lubricate and inspect bearings for wear.
- Inspect the indoor coil if accessible.
- Flush and treat the condensate drain with anti-algae agent.
- Inspect condensor coil.
- Monitor operating pressures of refrigerant.
- Inspect safety devices for proper operation.
- Inspect disconnect box for proper rating and installation.
- Tighten all electrical connections.
- Test and inspect contactors for burned, pitted contacts.
- Inspect and tighten all electrical connections.
- Test and inspect capacitors.
- Inspect fan blade.
- Clean the condesor coil, remove debris.
- Inspect service valves for proper operations.
- Measure temperature difference between supply and return.
- Inspect duct work for energy loss.
- Monitor compressor for proper amperage, volt draw and wiring connections.
|
